Ford Ecosport: Driveline
- Driveshaft
- Specifications
- Diagnosis and Testing - Driveshaft
- General Procedures - Driveshaft Angle Measurement
- General Procedures - Driveshaft Runout and Balancing
- Removal and Installation - Driveshaft
- Rear Drive Axle/Differential
- Specifications
- Diagnosis and Testing - Rear Drive Axle and Differential
- General Procedures - Active On-Demand Coupling Configuration
- General Procedures - Differential Draining and Filling
- General Procedures - Differential Fluid Level Check
- Removal and Installation - Active Torque Coupling Clutch
- Removal and Installation - Axle Assembly
- Removal and Installation - Differential Rear Bushing
- Removal and Installation - Rear Halfshaft Seal
- Front Drive Halfshafts
- Diagnosis and Testing - Front Drive Halfshafts
- Removal and Installation - Inner Constant Velocity (CV) Joint Boot
- Removal and Installation - Outer Constant Velocity (CV) Joint Boot
- Removal and Installation - Front Halfshaft RH - 2.0L Duratec-HE (125kW/170PS) – MI4, FWD
- Removal and Installation - Front Halfshaft RH - 2.0L Duratec-HE (125kW/170PS) – MI4, AWD
- Removal and Installation - Front Halfshaft LH - 6-Speed Automatic Transmission – 6F35
- Rear Drive Halfshafts
Removal and Installation - Tire Pressure Monitoring System (TPMS) Sensor
Removal
WARNING:
The Tire Pressure Monitoring System (TPMS) sensor
battery may release hazardous chemicals if exposed to extreme mechanical
damage...
Driveshaft
..
Other information:
Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Knock Sensor (KS)
Removal NOTE: Removal steps in this procedure may contain installation details. Remove the intake manifold. Refer to: Intake Manifold (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation). NOTE: Note the position of the components before removal. NOTE: Make sure that the components are installed to the position noted before..
Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Seat Position Sensor
Removal NOTE: LH power seat shown, other seats similar. NOTE: Removal steps in this procedure may contain installation details. Disconnect the electrical connector. Remove the screw. Torque: 8 lb.in (0.9 Nm) Remove the seat position sensor. Installation To insta..
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2026)
- General Procedures - Transmission Fluid Level Check
- Automatic Transmission - 6-Speed Automatic Transmission – 6F35
- Diagnosis and Testing - Evaporative Emissions
- Removal and Installation - Body Control Module (BCM)
- Description and Operation - Jacking and Lifting - Overview
Removal and Installation - Steering Column Shaft
Removal
NOTE: Removal steps in this procedure may contain installation details.
NOTICE: Do not allow the steering column to rotate while the steering column shaft is disconnected or damage to the steering column internal sensor may result.
NOTE: Use a steering wheel holding device (such as Hunter® 28-75-1 or equivalent)
Hold the steering wheel in the straight-ahead position.
Copyright © 2026 www.foecosport2.com