Ford Ecosport: Rear Drive Halfshafts / Removal and Installation - Outer Constant Velocity (CV) Joint Boot
Special Tool(s) /
General Equipment
|
204-169 Clamping Tool, Boot Retaining Clamp |
Materials
Name |
Specification |
Grease |
WSS-M1C272-A
|
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the inner CV joint boot.
Refer to: Inner Constant Velocity (CV) Joint Boot (205-05 Rear Drive Halfshafts, Removal and Installation).
-
Remove and discard the CV joint boot clamps.
-
Remove the outer CV joint boot.
Installation
-
NOTE:
Grease sachet is supplied with boot kit.
Install the outer CV boot and apply grease to the inside of CV boot.
Material: Grease
(WSS-M1C272-A)
-
NOTE:
Make sure that new components are installed.
NOTE:
Do not move the CV joint housing. Make sure that the CV joint boot is installed with the boot in the CV groove.
-
Using the special tool, position back the CV boot and install the new large halfshaft boot clamp.
Use Special Service Tool: 204-169
Clamping Tool, Boot Retaining Clamp.
-
Install the inner CV joint boot.
Refer to: Inner Constant Velocity (CV) Joint Boot (205-05 Rear Drive Halfshafts, Removal and Installation).
Other information:
Removal
WARNING:
The following procedure describes critical repair steps
required for correct seat component installation. Follow all notes and
steps carefully. Do not place any objects between the seat components
and the body of the vehicle, nor any objects within a joint internal to
the seat structure. Failure to follow step instructions may result in
incorrect operatio..
Repair
WARNING:
Service actions on vehicles equipped with electronic parking
brakes may cause unexpected parking brake application, which could
result in injury to hands or fingers. Put the electronic parking brake
system into service mode prior to servicing or removing rear brake
components. Failure to follow this instruction may result in serious
personal injury.
&..