Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the combination front fog lamp turn signal assembly bezel.
Use the General Equipment: Interior Trim Remover
..
Removal
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation.
Using a diagnostic scan tool, begin the PMI process for the TCU following the on-screen instructions.
NOTE:
Removal steps in this pro..