Ford Ecosport: Manual Transmission, Clutch, Transfer Case and Power Transfer Unit
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the RH steering wheel multifunction switch...
Other information:
B0052:11, B0052:12, B0052:13, B0052:1D
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the passenger seatbelt buckle sensor circuits for the following faults:
Open circuit
Short to voltage
Short to ground
Current out of range
Faulted passenger..
Bring the engine to normal operating temperature. Connect
the Vacuum/Pressure Tester to the intake manifold. Run the engine at the
specified idle speed.
The vacuum gauge should read between 51-74 kPa (15-22 in-Hg)
depending upon the engine condition and the altitude at which the test
is conducted. Subtract 4.0193 kPa (1 in-Hg) from the specified reading
for every..