Ford Ecosport: Acceleration Control / Removal and Installation - Accelerator Pedal
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
To prevent setting Diagnostic Trouble Codes (DTCs), make
sure that the Transmission shifter is in P position (Parking).
NOTE:
Make sure the ignition switch is in the OFF position for at
least 30 seconds, prior to disconnect the accelerator pedal electrical
connector.
-
-
Disconnect the accelerator pedal wiring harness electrical connector.
-
Remove the nuts and the accelerator pedal.
Torque:
18 lb.ft (25 Nm)
Installation
-
To install, reverse the removal procedure.
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Other information:
B0082:11, B0082:12, B0082:13, B0082:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the passenger seatbelt load limiter circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted passenger seatbelt load limite..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the A/C drive belt.
Refer to: Air Conditioning (A/C) Compressor Belt (303-05C Accessory
Drive - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
Remove the engine appearance cover.
WARNING:
The t..