Ford Ecosport: Instrumentation, Message Center and Warning Chimes / General Procedures - Seatbelt Minder Deactivating/Activating
Activation
WARNING:
Before beginning any service procedure in this section,
refer to Safety Warnings in section 100-00 General Information. Failure
to follow this instruction may result in serious personal injury.
NOTE:
The driver and passenger seat Belt-Minder® deactivating/activating can be carried out using the scan tool.
NOTE:
If you are using a MyKey® programmed key, the Belt-Minder®
cannot be disabled and does not time out after 5 minutes. If the
Belt-Minder® has been previously disabled, it is re-enabled when a
MyKey® programmed key is used.
NOTE:
The driver and front passenger Belt-Minder® are
deactivated/activated independently. When deactivating/activating one
seating position, do not buckle the other position.
-
Apply the parking brake before deactivating/activating the Belt-Minder®.
-
Place the selector lever in PARK (P).
-
Place the ignition in OFF.
-
Unbuckle the driver and the front passenger safety belts.
-
Place the ignition in the RUN mode (do not start the engine).
-
Wait until the safety belt warning indicator turns off (approximately 1 minute).
-
Wait an additional 5 seconds after the safety belt warning indicator turns off (step 6).
-
NOTE:
The procedure (steps 8 and 9) must be completed within 30 seconds once it is started.
For the seating position to be deactivated or activated,
buckle then unbuckle the safety belt 3 times at a moderate speed,
ending with the safety belt in the unbuckled state. After this step the
safety belt warning indicator turns on.
-
NOTE:
The safety belt warning indicator flashes as confirmation of a successful procedure.
Buckle then unbuckle the safety belt one time at a moderate speed.
-
After confirmation, the deactivation/activation procedure is complete for the selected seating position.
Activation
Without starting the engine, place the ignition in RUN.
Using the message center switch, navigate and select
MAINTENANCE from the menu...
Removal
NOTE:
LH shown, RH similar.
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new IPC , it is necessary to upload the module
configuration information to the scan tool prior to removing the IPC ...
Other information:
Removal
WARNING:
The following procedure describes critical repair steps
required for correct seat component installation. Follow all notes and
steps carefully. Do not place any objects between the seat components
and the body of the vehicle, nor any objects within a joint internal to
the seat structure...
Intermediate Clutch
For intermediate (2,6) clutch operation, REFER to: Transmission
Description (307-01B Automatic Transmission - 6-Speed Automatic
Transmission – 6F35, Description and Operation).
REFER to: Intermediate Clutch Assembly (307-01B Automatic Transmission -
6-Speed Automatic Transmission – 6F35, Description and Operation)...