Ford Ecosport: Engine System - General Information / General Procedures - Bearing Inspection
Inspection
-
-
Cratering - fatigue failure
-
Spot glazing - incorrect seating
-
Scratching - dirty engine oil
-
Base exposed - poor lubrication
-
Both edges worn - journal damaged
-
One edge worn - journal tapered or bearing not seated
Symptom Charts
Symptom Chart - Gasoline Engine Performance
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Make sure the oil in the crankcase is of the correct
viscosity and at the correct level and that the battery is correctly
charged. Operate the vehicle until the engine is at normal operating
temperature...
Other information:
U0146:00
Normal Operation and Fault Conditions
The RCM uses information contained in messages from the GWM sent on the HS-CAN2 .
DTC Fault Trigger Conditions
DTC
Description
Fault Trigger Conditions
U0146:00
Lost Communication with Gateway "A": No Sub Type Infor..
B140A:11, B140A:12, B140A:13, B140A:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver second row side airbag circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted driver second row side airbag
..