Ford Ecosport: Rear Disc Brake / Removal and Installation - Rear Brake Flexible Hose
Removal
All vehicles
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
Vehicles With: FWD
-
-
Disconnect the brake tube fitting.
Torque:
159 lb.in (18 Nm)
-
Remove the clip and detach the brake hose from the bracket.
Vehicles With: AWD
-
Detach the parking brake cable and the wheel speed sensor wiring from the bracket.
-
-
Disconnect the brake tube fitting.
Torque:
159 lb.in (18 Nm)
-
Remove the clip and detach the brake hose from the bracket.
-
Remove the bolt and detach the bracket.
Torque:
18 lb.ft (25 Nm)
All vehicles
-
Disconnect the brake hose fitting and remove the brake flexible hose.
Torque:
159 lb.in (18 Nm)
Installation
-
NOTICE:
Make sure the brake hose is not twisted when
installing the brake hose or damage to the brake flexible hose may
occur.
To install, reverse the removal procedure.
-
Bleed the brake system.
Refer to: Brake System Pressure Bleeding (206-00 Brake System - General Information, General Procedures).
Special Tool(s) /
General Equipment
Brake Caliper Piston Retractor
Materials
Name
Specification
Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake FluidPM-20
WSS-M6C65-A2
Multi-Purpose Grease
WSS-M12A4-A2
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Removal
Vehicles without overhead console
Position the microphone.
Disconnect and remove the microphone.
Vehicles with overhead console
Remove the overhead console.
Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).
..
U0100:00
Normal Operation and Fault Conditions
The RCM uses information contained in messages from the PCM sent on the HS-CAN .
DTC Fault Trigger Conditions
DTC
Description
Fault Trigger Conditions
U0100:00
Lost Communication with ECM/PCM “A”: No Sub Type I..