Ford Ecosport Owners and Service Manuals

Ford Ecosport: Body Closures / General Procedures - Front Door Alignment

Ford Ecosport 2014-2024 Service and Repair Manual / Body and Paint / Body Closures / General Procedures - Front Door Alignment

Inspection

NOTE: LH side shown, RH side similar.

  1. Check the body-to-front door dimensions.
    Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).

Adjustment

All alignments

  1. Open the front door.
  1. Remove the bolts and the striker assembly.

Front door in and out, up and down alignment

  1. Loosen the bolts enough to permit movement of the door.
  1. Adjust the door to specification.
    Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).
  1. Tighten the bolts.
    Torque: 30 lb.ft (40 Nm)

Front door fore, aft and tilt alignment

  1. Loosen the bolts enough to permit movement of the door.
  1. Carefully close the door.
  1. Adjust the door to specification.
    Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).
  1. Carefully open the door.
  1. Tighten the bolts.
    Torque: 26 lb.ft (35 Nm)

All alignments

  1. Install the striker assembly and the bolts.
    Torque: 177 lb.in (20 Nm)
  1. Check the body-to-front door dimensions.
    Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation).

    Body Closures

    ..

    General Procedures - Hood Alignment

    Inspection Inspect the hood-to-body dimensions. Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Description and Operation)...

    Other information:

    Ford Ecosport 2014-2024 Service and Repair Manual: Removal and Installation - Front Floor Panel Side Member


    Special Tool(s) / General Equipment Resistance Spotwelding Equipment Scraper for Straight Edges Hot Air Gun 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Materials Name Specification Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM -  Removal NOTE: Roof removed ..

    Ford Ecosport 2014-2024 Service and Repair Manual: Removal and Installation - Ambient Air Temperature Sensor


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the front bumper cover. Remove the ambient air temperature sensor. Disconnect the electrical connector. Detach and remove the ambient air temperature sensor. Installation To install..

    Categories

    Removal and Installation - Front Stabilizer Bar

    Special Tool(s) / General Equipment

    Tie Rod End Remover Transmission Jack

    Removal

    NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

    NOTE: Removal steps in this procedure may contain installation details.

    NOTICE: Disconnect the b

    read more

    Copyright © 2024 www.foecosport2.com