Ford Ecosport Owners and Service Manuals

Ford Ecosport: Instrumentation, Message Center and Warning Chimes / Description and Operation - Warning Chimes - Overview

Overview

The warning chimes provide the driver with audible warnings that act as reminders and supplemental alerts to visual IPC indications such as gauges, indicators and message center warnings. The IPC controls all warning chimes based on messages received from external modules. The IPC prioritizes the chimes according to a preset hierarchy programmed into the IPC software. When more than one chime request is received by the IPC , the most important chime sounds. If a lower priority chime is currently sounding, the higher priority request takes over and replaces or delays the lower priority chime.

The warning chimes are sounded through the audio system speakers and the IPC . The turn signal/hazard on (tick-tock) is the only individual chime that sounds through the IPC , not the audio system. All other warning chimes are sounded through the front or rear audio system speakers.

The IPC also acts as a backup. In the event of an audio system chime failure, the IPC sounds all chimes that are required.

NOTE: There are instances where some of the chimes may sound through the IPC and should not be interpreted as a fault in the audio system. An example might be when the ignition is off, with the key in the igntion and the driver door ajar. In this instance, the audio system is offline and the key-in-igntion chime defaults to the IPC .

    Description and Operation - Message Center - System Operation and Component Description

    S..

    Description and Operation - Warning Chimes - System Operation and Component Description

    System Operation System Diagrams Base AM/FM Audio System Item Description 1 IPC chime arbitrator 2 Airbag warning chime 3 Message center chime 4 Belt-Minder® warning chime 5 Door ajar warning chime 6 Headlamps on warning chime 7 Low fuel warning chime 8 Perimeter alarm chime ..

    Other information:

    Ford Ecosport 2014-2024 Service and Repair Manual: Description and Operation - Communications Network - Overview


    Overview Multiplexing is a method of sending 2 or more signals simultaneously over a single circuit. Multiplexing allows 2 or more electronic modules (nodes) to communicate over a twisted wire pair [data (+) and data (-)] network. The information or messages that can be communicated on these wires consists of commands, status or data. Multiplexing reduces the weight of the vehicle by..

    Ford Ecosport 2014-2024 Service and Repair Manual: Removal and Installation - Keyless Entry Rear Antenna


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the luggage compartment floor cover. Position the liftgate weatherstrip aside. Remove the load compartment scuff plate trim panel. Remove the pin-type retainers. ..

    Categories

    Removal and Installation - Front Brake Flexible Hose

    Removal

    Remove the wheel and tire.
    Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).

    Remove the brake flexible hose bracket bolt.
    Disconnect the brake tube fitting and remove the brake hose clip.
    Loosen the brake hose fitting and remove the brake flexible hose.

    read more

    Copyright © 2024 www.foecosport2.com