Ford Ecosport: Anti-Lock Brake System (ABS) and Stability Control / Removal and Installation - Rear Wheel Speed Sensor - FWD
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Note the position of the rear wheel speed sensor before removal.
-
Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
-
Disconnect the electrical connector and detach the wiring retainers.
-
NOTICE:
Make sure that the area around the component is clean and free of foreign material.
Detach the wiring retainer, remove the bolt and the rear wheel speed sensor.
Torque:
80 lb.in (9 Nm)
Installation
-
NOTE:
Make sure that this component is installed to the noted removal position.
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Note the position of the rear wheel speed sensor before removal...
Other information:
Introduction
WARNING:
Before beginning any service procedure in this manual, refer
to health and safety warnings in section 100-00 General Information.
Failure to follow this instruction may result in serious personal
injury.
For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
This
manual ..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front door window regulator.
Refer to: Front Door Window Regulator (501-11 Glass, Frames and Mechanisms, Removal and Installation).
Remove the front door window regulator motor.
Remove the front door window regulator motor bolt.
Torque:
35 lb.i..