Ford Ecosport: Rear Disc Brake / Removal and Installation - Brake Disc
Materials
Name |
Specification |
Motorcraft® Metal Brake Parts Cleaner PM-4-A, PM-4-B, APM-4-C |
-
|
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
-
NOTE:
Make sure new bolts are installed.
Remove the bolts and position the brake caliper and anchor plate assembly aside. Discard the bolts.
Torque:
46 lb.ft (63 Nm)
-
Remove the brake disc.
Installation
-
NOTE:
Make sure the mating surfaces are clean and free of foreign material.
Clean the brake disc mating surfaces using a wire brush and the specified material.
Material: Motorcraft® Metal Brake Parts Cleaner
/ PM-4-A, PM-4-B, APM-4-C
-
NOTICE:
Make sure that the brake hose is not twisted when
installing the brake caliper or damage to the brake flexible hose may
occur.
To install, reverse the removal procedure.
-
Apply the brake pedal several times to verify correct brake system operation.
Removal
NOTE:
Steps in the removal procedure may contain installation details.
Remove the brake pads.
Refer to: Brake Pads (206-04 Rear Disc Brake, Removal and Installation)...
Removal
Vehicles With: FWD
NOTE:
Removal steps in this procedure may contain installation details.
Remove the wheel hub.
Refer to: Wheel Hub - Vehicles With: Rear Disc Brakes (204-02A Rear Suspension - FWD, Removal and Installation)...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
DDM shown, PDM similar.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the diagnostic scan tool
prior to removing the module...
Special Tool(s) /
General Equipment
204-169Clamping Tool, Boot Retaining Clamp
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the tie rod end.
Refer to: Tie Rod End (211-02 Power Steering, Removal and Installation)...