Ford Ecosport: Automatic Transmission External Controls / Description and Operation - External Controls - Component Location
Ford Ecosport 2014-2024 Service and Repair Manual / Automatic Transmission / Automatic Transmission External Controls / Description and Operation - External Controls - Component Location
6F15
| Item | Description |
|---|---|
| 1 | Selector lever knob |
| 2 | Selector lever bezel |
| 3 | Brake shift interlock actuator |
| 4 | Selector lever cable adjuster |
| 5 | Selector lever cable |
| 6 | Selector lever assembly |
| 7 | SelectShift® switch (if equipped) |
6F35
| Item | Description |
|---|---|
| 1 | Selector lever knob |
| 2 | Selector lever bezel |
| 3 | Brake shift interlock actuator |
| 4 | Selector lever cable adjuster |
| 5 | Selector lever cable |
| 6 | Selector lever assembly |
| 7 | SelectShift® switch (if equipped) |
Paddle Switches
| Item | Description |
|---|---|
| 1 | Downshift paddle switch (if equipped) |
| 2 | Upshift paddle switch (if equipped) |
Description and Operation - External Controls - Overview
Overview
The transmission selector lever linkage consists of:
a selector lever cable that connects the transmission manual control lever to the selector lever assembly...
Other information:
Ford Ecosport 2014-2024 Service and Repair Manual: Removal and Installation - Rear Lamp Bulb
Removal Turn signal bulb NOTE: RH rear lamp assembly shown, LH rear lamp assembly similar. Remove the rear lamp assembly. Refer to: Rear Lamp Assembly (417-01 Exterior Lighting, Removal and Installation). Remove the screws and the and the bulb holder...
Ford Ecosport 2014-2024 Service and Repair Manual: General Procedures - Brake System Pressure Bleeding
Special Tool(s) / General Equipment Brake/Clutch System Pressure Bleeder/Filler Fluid Container Bleeding All vehicles NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water...
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2024)
- Removal and Installation - Fuel Pump and Sender Unit
- Body and Paint
- Climate Control System - General Information
- Removal and Installation - Starter Motor
- Removal and Installation - Body Control Module (BCM)
Removal and Installation - Oil Pressure Switch
Materials
Name Specification Motorcraft® Thread Sealant with PTFETA-24-B WSK-M2G350-A2
Removal
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
If equipped, remove the bolts and the underbody shield.
Copyright © 2024 www.foecosport2.com