Ford Ecosport Owners and Service Manuals

Ford Ecosport: Engine System - General Information / Description and Operation - Engine - Overview

Engine Information

NOTE: When repairing engines, all parts must be contamination free. If contamination/foreign material is present when repairing an engine, premature engine failure may occur.

NOTE: Specifications show the expected minimum or maximum condition. Refer to the appropriate section in Group 303 for the specifications.

NOTE: If a component fails to meet the specifications, it is necessary to refinish it or install a new component. Wear limits are provided as an aid to determine if the component can be refinished. A new component must be installed when any component fails to meet specifications and cannot be refinished.

NOTE: This section contains information, steps and procedures that may not be specific to this engine.

This section covers general procedures and diagnosis and testing of the engine system, except for exhaust emission control devices, which are covered in the PC/ED manual.

The engine incorporates the following features: Refer to the appropriate section in Group 303 for the procedure.

  • Crankcase ventilation or breather system
  • Exhaust emission control system
  • EVAP

Some engines incorporate a fail-safe cooling system. Refer to the appropriate section in Group 303 for the procedure.

The engine, fuel system, ignition system, emissions system and exhaust system all affect exhaust emission levels and must be maintained according to the maintenance schedule. Refer to the Scheduled Maintenance Guide.

Correct engine identification is required to order parts. Refer to the appropriate section in Group 303 for the procedure.

For complete vehicle and engine identification codes,
Refer to: Identification Codes (100-01 Identification Codes, Description and Operation).

    Engine System - General Information

    ..

    Diagnosis and Testing - Engine

    Symptom Charts Symptom Chart - Gasoline Engine Performance Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...

    Other information:

    Ford Ecosport 2014-2025 Service and Repair Manual: Removal and Installation - Powertrain Control Module (PCM)


    Special Tool(s) / General Equipment Ford Diagnostic Equipment Removal NOTE: Removal steps in this procedure may contain installation details. If installing a new PCM , connect a battery charger to the battery to make sure it is charged to maintain proper battery voltage...

    Ford Ecosport 2014-2025 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: U


    U0100:00 Normal Operation and Fault Conditions The RCM uses information contained in messages from the PCM sent on the HS-CAN .   DTC Fault Trigger Conditions   DTC Description Fault Trigger Conditions U0100:00 Lost Communication with ECM/PCM “A”: No Sub Type I..

    Categories

    Removal and Installation - Oil Pressure Switch

    Materials

    Name Specification Motorcraft® Thread Sealant with PTFE
    TA-24-B WSK-M2G350-A2
     

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
    If equipped, remove the bolts and the underbody shield.

    read more

    Copyright © 2025 www.foecosport2.com