Ford Ecosport: Handles, Locks, Latches and Entry Systems / Removal and Installation - Tailgate Release Handle
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the tailgate latch.
Refer to: Tailgate Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
-
Remove the tailgate release handle.
-
Release the tailgate release handle.
-
Remove the tailgate release handle.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Other information:
B1413:11, B1413:12, B1413:13, B1413:96
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM monitors the front impact severity sensor circuits for the following faults:
Open circuit
Short to voltage
Short to ground
Faulted front impact severity sensor
If a fault is detec..
Check
NOTE:
Wheel-to-hub optimization is important. Clearance between
the wheel and hub can be used to offset or neutralize the Road Force® or
run-out of the wheel and tire assembly. For every 0.001 inch of
wheel-to-hub clearance, the Road Force® can be affected between 1 and 3
pounds depending on the tire stiffness.
NOTE:
The example below illustrates how the cl..