Ford Ecosport: Multifunction Electronic Modules / General Procedures - Transport Mode Deactivation
Deactivation
NOTE:
After vehicle build, some vehicle modules are set in Transport mode
including the IPC and the BCM . Transport mode reduces battery drain
during longer periods where the vehicle is not used. While in transport
mode, the IPC
displays TRANSPORT MODE CONTACT DEALER in the message center. Various
systems may be altered or are disabled when in the transport mode. The
vehicle automatically reverts to normal operation mode after being
driven 201 km (125 mi). The vehicle can be manually taken out of
Transport mode using this procedure.
If the IPC displays FACTORY MODE CONTACT DEALER in the message center the vehicle is set in factory mode. The system
does not automatically revert to another mode and must be manually set to either the transport or normal operation mode. Refer to the
Factory Mode Deactivation procedure in this section.
-
WARNING:
Before beginning any service procedure in this
manual, refer to health and safety warnings in section 100-00 General
Information. Failure to follow this instruction may result in serious
personal
Place the ignition in the OFF position.
-
Verify the battery is fully charged.
Refer to: Battery Charging (414-01 Battery, Mounting and Cables, General Procedures).
-
Place the ignition in the ON position.
-
NOTE:
Steps 4 and 5 must be carried out within 10 seconds.
Press and release the brake pedal 5 times.
-
NOTE:
The IPC message center indicates NORMAL MODE when the procedure has been successfully completed.
Press and release the hazard switch 2 times.
-
Start the engine.
-
Place the ignition in the OFF position.
-
Verify the RKE works correctly.
Deactivation
NOTE:
During vehicle build, some modules, such as the IPC and BCM are set in factory mode.
Factory mode reduces the drain on the battery during longer periods
where the vehicle is not used...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the diagnostic scan tool
prior to removing the module...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information.
Failure to follow this instruction may result in serious personal
injury...
Special Tool(s) /
General Equipment
100-002
(TOOL-4201-C)
Holding Fixture with Dial Indicator Gauge
Inspection
NOTE:
Driveline vibration exhibits a higher frequency and lower
amplitude then high-speed shake. Driveline vibration is directly related
to the speed of the vehicle and is noticed at various speeds...