Ford Ecosport: Roof Opening Panel / Specifications

Ford Ecosport 2014-2024 Service and Repair Manual / Body and Paint / Roof Opening Panel / Specifications

Specifications

Item	Specification
Sliding glass panel to roof flushness, front	-0.02 ± 0.04 in (-0.5 mm ± 1.0 mm)
Sliding glass panel to roof flushness, rear	0.02 ± 0.04 in (0.5 ± 1.0 mm)

Roof Opening Panel

Description and Operation - Roof Opening Panel - Overview

Overview The roof opening panel consists of the following: Air deflector Roof opening panel frame Roof opening panel glass Roof opening panel motor Roof opening panel shield Roof opening panel drain hoses Roof opening panel control switch Trough assembly The roof opening panel motor must be initialized when repairs are..

Other information:

Ford Ecosport 2014-2024 Service and Repair Manual: Removal and Installation - Rear Exhaust Mounting Bracket

Special Tool(s) / General Equipment 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Removal NOTE: Factory welds may be substituted with resistance or metal inert gas (MIG) plug welds. Resistance welds may not be placed directly over original location. They must be placed adjacent to original location and match factor..

Ford Ecosport 2014-2024 Service and Repair Manual: Removal and Installation - Passive Anti-Theft System (PATS) Front Antenna

Removal Remove the floor console. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation). Disconnect the PATS front antenna electrical connector. Release the tabs and remove the PATS front antenna. Installation To install, rev..

Removal and Installation - Variable Camshaft Timing (VCT) Unit

Removal

NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

Remove the timing chain.
Refer to: Timing Chain (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
Remove the bolts and VCT units.
Discard the bolts.