Ford Ecosport Owners and Service Manuals

Ford Ecosport: Generator and Regulator / Specifications


  General Specifications


Item Specification
1.0L EcoBoost (92kW/125PS)
Rating 150 amps
Generator amps at 80.6 °F ( 27 °C) 78 amps at 680 rpm (min) to 158 amps at 2,250 rpm (max)
Generator pulley ratio 2.65:1
Generator pulley replaceable No
Generator pulley type Overrunning Alternator Decoupler (OAD)
Voltage regulator type Electronic internal with generator
1.5L Duratec (90kW/120PS) – I3
Rating 140 amps
Generator amps at 80.6 °F ( 27 °C) 62 amps at 680 rpm (min) to 145 amps at 2,200 rpm (max)
Generator pulley ratio 2.65:1
Generator pulley replaceable No
Generator pulley type Overrunning Alternator Decoupler (OAD)
Voltage regulator type Electronic internal with generator
2.0L Duratec – HE (129kW/175PS)
Rating 150 amps
Generator amps at 80.6 °F ( 27 °C) 75 amps at 720 rpm (min) to 153 amps at 2,400 rpm (max)
Generator pulley ratio 2.51:1
Generator pulley replaceable No
Generator pulley type Overrunning Alternator Decoupler (OAD)
Voltage regulator type Electronic internal with generator

    Generator and Regulator

    ..

    Removal and Installation - Generator - 2.0L Duratec-HE (129kW/175PS)

    Removal NOTE: Removal steps in this procedure may contain installation details. With the vehicle in NEUTRAL, position it on a hoist...

    Other information:

    Ford Ecosport 2014-2024 Service and Repair Manual: Removal and Installation - Condenser Outlet Line - 2.0L Duratec-HE (129kW/175PS)


    Removal NOTICE: During the removal of components, cap, tape or otherwise appropriately protect all openings to prevent the ingress of dirt or other contamination. Remove protective materials prior to installation. NOTE: Removal steps in this procedure may contain installation details...

    Ford Ecosport 2014-2024 Service and Repair Manual: Removal and Installation - A-Pillar Outer Panel Section and Reinforcement


    Special Tool(s) / General Equipment Resistance Spotwelding Equipment 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Removal NOTE: Factory welds may be replaced with resistance spot welds or MIG (metal inert gas) plug welds...

    Categories

    Removal and Installation - Wheel Knuckle Bushing

    Special Tool(s) / General Equipment

    Hydraulic Press

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    Remove the wheel knuckle.
    Refer to: Wheel Knuckle - Vehicles With: Rear Drum Brakes (204-02B Rear Suspension - AWD, Removal and Installation).
    Remove the rear toe adjustment retainers and remove the wheel knuckle mounting bracket.
    Torque:
      Stage 1:  177 lb.in (20 Nm)
      Stage 2:  76 lb.ft (103 Nm)

    read more

    Copyright © 2024 www.foecosport2.com