Ford Ecosport: Battery, Mounting and Cables / Removal and Installation - Battery Cables - 2.0L Duratec-HE (125kW/170PS) – MI4
Removal
-
NOTE:
The starter and generator electrical connector and
terminals are integrated into the engine wiring harness and the battery
positive terminal is integrated into the Battery Junction Box (BJB).
Remove the negative battery cable.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Disconnect the battery.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures)...
Removal
NOTE:
When the battery is disconnected and connected, some
abnormal drive symptoms may occur while the vehicle relearns its
adaptive strategy...
Other information:
Description
Value
Distance - ground to headlamp centre
890 mm
Distance - ground to fog lamp centre
628 mm
Headlamp setting
X = 10 cm/10 m = 0°34' = 1...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Lower the headliner.
Refer to: Headliner - Lowering (501-05 Interior Trim and Ornamentation, Removal and Installation).
Place the roof opening panel glass to the fully CLOSE position...